jalex

Lines and triangles make up this punch design from fabric squares. This easy technique can be used with a variety of materials and styrofoam.

You will need:

1" x 8" x 10" Styrofoam® sheet
1/8 yd Blue, 1/3 yd White and 5/8 yd Red
44/45" wide cotton fabric 44" Red 7/8" Grosgrain ribbon
1 1/2" Picture hanger with nails
Tacky Glue
Scissors
Sheet of white 8 1/2" x 11" paper
Fine point permanent marker.
#2 pencil
Straight pins


Instructions:

Measure and draw the flag design on the Styrofoam as shown on the diagram. Copy the star pattern onto a piece of paper, cut out. Pin in place in the center of the 4" x 5" section of the Styrofoam. Trace around with a marker, then remove.



Cut a 9" x 11" piece of red fabric and set aside. Cut remaining red, blue and white fabric into 1 1/2" strips. Cut the strips again into 1 1/2" squares.


Spread a thin layer of glue inside the star outline. Place a piece of white fabric over the end of the pencil then, using the pencil as a tucking tool, push the fabric about 1/4" into the styrofoam. Placing the fabric tufts about 1/2" apart fill the star with white. Using the same technique fill the area around the star with blue fabric tufts and stripes with red and white.


Glue large piece of red fabric on the back with the excess on the sides, then glue ribbon around the edge.


Glue the hanger to the center back of flag 1" below top. Place glue on nails and push thru holes into flag.

© Copyright 2001 Katherine Stull, Inc.

__________________
Get our guys out of Iraq!!

jalex

always liked this one...bumpt

__________________
Get our guys out of Iraq!!